top of page

These AUTOMOTIVE PROBLEM SOLVERS may help you.
This information is a GUIDE ONLY and is from MY EXPERIENCES and others who have willingly shared their knowledge. 

 

All these products are specialist products that we manufacturer or import and are available from this website. 
A limited number of retailers do stock some of our products.

2. Boat Trailer Wheel Bearings Not Lasting.

Do you have the problem of each time you go for a WOF you need to replace your trailer wheel bearings?
The answer is to use our special Copper and Lead impregnated grease to pack your wheel bearings.
The Copper & Lead will coat your bearing to help stop the salt water attacking the metal surfaces. 

From my experience you should get 5 or 6 times more bearing life. Yes a huge improvement. 

 

This product is a specialist product Pro-Ma MBLGrease so please give Ross a call on +64 21 892-179 if in any doubt about its use. 
This product is only available from this website and is not available in stores.

 

GO TO PRODUCT

7. Noisy Power Steering.

If you have a noisy Power Steering pump and the problem is NOT an air lock problem then we have had good results using NPS.

Dosage: Shake the bottle and add only a teaspoon while the engine is idling.

 

This product is a specialist product Pro-Ma MBL8 so please give Ross a call on +64 21 892-179 if in any doubt about its use. 
This product is available from this website and also at BNT, Repco & Partmaster, prices may vary.

 

GO TO PRODUCT

8. Valves Sticking Open Due To Carbon Buildup.

This can be a problem when there is either too much carbon build up on the valve stem, or under the valve seat.

This is easily solved by adding a bottle of One Shot Rapid Fuel System Cleaner to a FULL tank of fuel.

This product is a specialist product Pro-Ma One Shot Fuel System Cleaner so please give Ross a call on +64 21 892-179 if in any doubt about its use. 
This product is available from this website.


GO TO PRODUCT

9. Diesel Smokey or Hard To Start.

If your Diesel vehicle is hard to start there can be several reasons.

Firstly Diesels need good compression to start, if your engine is tired it will be harder to start.
By adding our Diesel Treatment this should help with starting for both cold conditions and slightly tired engines. 

If your Diesel vehicle is smokey that is usually caused by worn injectors.
Again Our Diesel Treatment will help to REDUCE SMOKE by helping the fuel to burn better turning what was black smoke (unburnt fuel) into more usable power.

BUT NOTE: If your diesel is badly smoking there is only one answer get a diesel injection repairer to repair it properly.

This product is a specialist product Pro-Ma Diesel Treatment so please give Ross a call on +64 21 892-179 if in any doubt about its use. 
This product is available from this website and some Repco stores, note prices may vary

 

GO TO PRODUCT

10. Piston Hitting Head Due To Carbon Buildup.

If your petrol powered car is sluggish, has been checked and there appears to be NO mechanical fault, I suggest adding a bottle of One Shot Rapid Fuel System Cleaner to a full tank of Petrol. 

We have had very good results on these problem cars.

This product is a specialist product Pro-Ma One Shot Fuel System Cleaner so please give Ross a call on +64 21 892-179 if in any doubt about its use. 
This product is available from this website.

 

GO TO PRODUCT

11. Cracked Head or Blown Head Gasket.

If your vehicle is using water and has a suspected Cracked Head or Blown Head Gasket WORKSHOP LIQUID GLASS could solve your problem.

Simply add a bottle to your cooling system and the Liquid will find the leak and seal it in over 90% of situations.

 

This product is a specialist product Pro-Ma One Shot Fuel System Cleaner so please give Ross a call on +64 21 892-179 if in any doubt about its use. This product is available from this website and also at Auto Radiators Auckland, Coombes & Rennie Hamilton, Hutt City Auto Parts & Rangiora Radiators, prices will vary.

 

GO TO PRODUCT

PROBLEM SOLVERS

1. Noisy Hydraulic Lifters.

Noisy Hydraulic lifters are easy to cure on 90% of vehicles.
It is usually caused by either a lack of oil pressure to the lifter or a stuck lifter. 
My vast experience shows that far less than 10% of the time does the lifter actually need replacing.

It appears to be a common problem with a wide range of vehicles including Subaru, Mitsubishi, Ford, Holden, Isuzu, also most of the V6 petrol engine range of most makes, some diesels, and some of the European vehicles, basically if it has Hydraulic lifters it can cause you problems.

I have an easy cure with at least a 90% success rate that most Automotive Repair Shops and Mechanical Warranty companies in New Zealand now use to solve this annoying tapping problem.
 

I have been able to get Subarus that have dropped to 3 cylinders back to full operation using this additive.....
I have had a Nissan Maxima that sounded like the piston was trying to get out, quieten down in less than 1km ....
I have had mechanics who do not believe additives work ring me after they have fitted new lifters and the noise is still there to see if I can help - after dosing with this additive I have solved their problem ....
I could bore you to death but it does work that's why so many mechanics now use it.

Dosage: 125ml per car

It is NOT recommended to use a Flush as this may cause more problems as carbon is dislodged in the engine.

 

This product is a specialist product Pro-Ma MBL8 so please give Ross a call on +64 21 892-179 if in any doubt about its use. 
This product is available from this website and also at BNT, Repco & Partmaster, prices may vary.

 

GO TO PRODUCT

3. Remove Oil From Your Cooling System.

After an oil cooler fault or a blown head gasket often oil ends up in the cooling system. 

This oil is very hard to remove and even if you are successful there is always an oily film on top of the water.

The answer is to flush the contaminated cooling system out with a bottle of Workshop Radiator De-Oiler, it is quick to use and does an excellent job. 

Even a badly oiled up system is no problem to Workshop Radiator De-Oiler, as long as there is some circulation.

This product is a specialist product Workshop Radiator De-Oiler which we make so please give Ross a call on +64 21 892-179 if in any doubt about its use. 
This product is available from this website and also at BNT, Bindons, Auto Radiators Auckland, Trevor French Radiators, Coombes & Rennie, Monteith & Parker, Crawford Radiators, Townrow & Sanko, Auto 1 Gisborne, Taylor Engineering & Radiator Wanganui, Hutt City Auto Parts, Radiator Services Blenheim, Auto Radiators Nelson, Rangiora Radiators, Muirs Radiators, prices may vary.

 

GO TO PRODUCT

4. Vehicle Shudder at approx 60-80km/h.

This could be one of those traps for young players. 
Check the exhaust of the vehicle does it go close by the inner CV Boot.

If so check that the inner CV grease has not dried out from the heat.

I am told some SUBARU'S and MITSUBISHI'S can strike this problem, but I am sure they are not the only ones.

 

GO TO PRODUCT

 

5. Notchy Gears Manual Gearbox.

If your manual gearbox is notchy (as opposed to graunchy) when changing down, our manual gearbox additive should help. It will get better and better the more the gearbox is used.

Dosage: 20ml per litre of gear oil

 

This product is a specialist product Pro-Ma MBL8 so please give Ross a call on +64 21 892-179 if in any doubt about its use. 
This product is available from this website and also at BNT, Repco & Partmaster, prices may vary.

 

GO TO PRODUCT

6. Sluggish Car Problems.

If your petrol powered car is sluggish, has been checked and there appears to be NO mechanical fault, I suggest adding a bottle of One Shot Rapid Fuel System Cleaner to a full tank of Petrol. 

We have had very good results on these problem cars.

This product is a specialist product Pro-Ma One Shot Fuel System Cleaner so please give Ross a call on +64 21 892-179 if in any doubt about its use. 
This product is available from this website.

 

GO TO PRODUCT

12. CVT Shudder.

CVT shudder in your Honda Fit or Honda Jazz is easily resolved. 

It also seems to smooth out other vehicles with CVT shudders as well.

  
The remedy is usually as simple as adding a bottle of WORKSHOP CVT ADDITIVE.

This product is a specialist product Workshop CVT Additive so please give Ross a call on +64 21 892-179 if in any doubt about its use. 
This product is available from this website and also Bindons & Hutt City Auto Parts.

 

GO TO PRODUCT

Noisy Hydraulic Lifters
Boat Trailer Wheel Bearings
Sluggish Car Problems
Remove Oil From Your
Notchy Gears
Piston Hitting
Noisy Power
Valves Sticking
Diesel Smokey
Cracked Head or Blown Head Gasket
CVT Shudder
bottom of page